Molex Connector MX-DaSH Wire-to-wire Connector Series Features Overview

The MX-DaSH wire-to-wire connector series is known for its light weight, compact size, and competitive pricing. Simplifying the assembly process, the MX-DaSH connectors support the partitioning architecture of the automobile by replacing multiple legacy connectors in vehicle applications by integrating power circuits, ground circuits, and high-speed data connections into a single connector.

▲MX-DaSH wire-to-wire connector series products

Featured Advantages

Optimize wire harnesses by combining multiple connectors into a single connector

The design combines 1.20, 1.50 and 2.80mm terminal subsystems to integrate power, signal and data connections as well as a high-speed FAKRA Mini (HFM) module for high-speed data transfer.

T2/V1/S3 grade seals and gasket options are available to ensure reliable operation of the connector in harsh conditions

The gasket design eliminates the need to individually seal each cable, reducing package size and lowering the cost of connectors in harsh environments both inside and outside the vehicle cabin.

Ensure safe mating and reliable connections

The connector can be equipped with an independent secondary lock (ISL), a Pin Pin Protection Plate (PPP), and a protection device to provide terminals.

Prevents misalignment and minimizes assembly errors

Features 4 unique locking slots to ensure proper mating orientation.

Markets and Applications

▲Autonomous Driving Module

01

motor vehicles

Autopilot Module

computational module

camera system

Gateway/Switch Module

GPS device

02

motor vehicles

High-resolution displays (4K displays)

High-speed cable networks

Sensor-equipment connectors

camera looking around

LiDAR laser radar equipment

▲Camera system

    ▲GPS

03

Commercial vehicles

GPS device

Infotainment equipment

Specification

reference information

Packing: Bag

Female/Male:

Plastic case - up to 31 bits + data

Terminals - 1.20 mm or 1.50 mm (power or signal) or 2.80 mm (power)

Data - HFM or H-MTD

Terminal wire diameter:

1.20 mm terminals - 0.35 to 1.50 mm2 wire gauge

1.50 mm terminals - 0.50 to 1.50 mm2 wire gauge

2.80 mm terminals - 2.00 to 2.50 mm2 wire gauge

Matching requirements: coding error-proofing

Design unit of measure: millimeters

RoHS compliant: Yes

Mechanical parameters

Holding force of the terminals with independent secondary lock (ISL): 100 Nm (min.)

Matching force (max): 70 Nm

Separation force (max.): 70 Nm

Electrical parameters

Voltage (maximum): 250 volts

Current (max.): refer to derating curve

Insulation resistance: 100 megohms (minimum)

physical parameter

Shell: Polyamide (PA66)

Contacts: Tin-plated

Vibration environment:

Acceleration - 9G (88 meters/square second)

Frequency - 20 to 200 Hz

Sealing Performance (Sealed Type)

Initial - 50kPa (minimum)

After durability test - 30kPa (min)

High Pressure Cleaning Test - IP69K

Operating temperature: -40 to +120 degrees Celsius or -40 to +85 degrees Celsius (varies by connector type)